Two opposed V-shaped guide units are obtained directly in the anodized
aluminium cylinder liner, on which a cover with two acetalic resin wearresistant
pads slides.
The cover has a tip-up-type carriage-piston rod coupling. In this way
the carriage only transfers loads axially and does not support loads
and moments in other directions.
The play of the pads can be adjusted by means of side threaded grub
screws. Therefore, it is possible to recover the wear of pads, which can be
replaced without the need for dismantling the cylinder.
This family of rodless cylinders has the same features as the basic versions:
such as an integrated adjustable pneumatic cushioning, sensor slots
and accessory holding slots.
A version is available with adjustable limit switches and hydraulic
decelerators. They can be purchased separately and applied at any time
to the basic cylinders as well.